|
|
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Collar Badge Fittings
Hi All,
Does anyone know when the anodised collar badges changed from having the single post fitting with the brass plate and split pin to the current version with the two pins and butterfly clips? Thanks a lot, Michael |
#2
|
||||
|
||||
The change was made when FAD (No2) Dress was introduced in and around 2016.
|
#3
|
||||
|
||||
Thanks Alan,
Any idea why? Is the materiel thinner so it's an easier way of fitting them? Just curious. Michael |
#4
|
||||
|
||||
Using clutch pins causes less damage to the uniform.
The change also includes shoulder titles with clutch pin fittings although these were introduced before FAD. Tim
__________________
"Manui dat cognitio vires - Knowledge gives strength to the arm" "Better to know it but not need it than to need it and not know it!" "Have more than thou showest, speak less than thou knowest." Last edited by grey_green_acorn; 28-05-20 at 10:36 AM. |
#5
|
||||
|
||||
Thanks Tim,
That makes sense. Michael |
#6
|
||||
|
||||
One of the big reasons was to reduce tailoring costs. Previously there was payment required by ‘contractors’ (unit tailors long gone apart from the Guards) for the piercing of holes and then whip stitching for collar badges. Also some collar badges required two holes rather than one, and orientation was sometimes different too. Consideration was even given to transferees having to change jackets because of holes. By changing the collar badge fixture to a pin that could pierce the cloth it removed all these pitfalls and left tailors contractors largely required to just fitting badges of rank and for the most part just one qualification badge where appropriate, albeit with a few exceptions. As always, it was essentially a cost savings measure.
|
|
|