|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Plastic ATS
I picked up a plastic Ats at the gunshow this weekend. It has a makers mark on the slider but all that is legible is ------ LTD BHAM... Can anyone help with the maker? Thanks Jim A
|
#2
|
||||
|
||||
plastic ATS
If it is the same as mine it reads "JR&L LTD B'HAM" on the slider.
|
#3
|
||||
|
||||
All 254,000 plastic ATS badges were made between 18-04-42 to 05-09-45 by Jarrett, Rainsford and Laughton Ltd.
Rgds, fougase1940. |
#4
|
|||
|
|||
Thanks for the info... that would be it... I was trying to make out a stanley or wallis maker mark and they weren't fitting the bill.... Jim
|
#5
|
||||
|
||||
Quote:
Rgds, fougasse1940. |
#6
|
|||
|
|||
You are right... I was going by memory and thouight there was a Wallis manufacturer ... excuse my red face
|
#7
|
||||
|
||||
I was under the impression that all 'Plastic' Cap Badges were produced with thin brass blades and not Sliders, and that the makers mark was impressed into the back of the badge. Is this not the case with the ATS badge? and if so what other badges were produced with sliders?
Any chance of a picture of one (rear)? |
#8
|
||||
|
||||
Quote:
The RA gun and RAPTC badges are also slidered. Rgds, fougasse190 |
#9
|
||||
|
||||
Those 2 were made with brass sliders where as the ATS had a plastic one. The only other slidered one that I know of is the Q/C KRRC which had a brass sldier as well.
|
|
|