|
|
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
OFFICERS BLADE PLACEMENT
Hi Guys
I have obtained a WWI officers soft kharkie cap to the front is 3 holes for blades the bottom 2 are 37 mm apart the top one is 17mm higher than the bottom 2 and in dead center I have gone through my wife badges and found that the Officers RA 3 blade badges are to wide to fit it having looked at 3 examples of these badges they are to wide and to tall my next port of call was my ox and bucks officers badges how ever they are again not in the right locations for the holes I cant think of any other 3 bladed officers cap badges any idears ? steve |
#2
|
||||
|
||||
Quote:
Last edited by wright241; 11-09-13 at 12:16 PM. Reason: typo - "about" & full RA title added |
#3
|
||||
|
||||
There are officer's badges with three loops too !
|
#4
|
||||
|
||||
RA = Royal Artillery GUNNERS or long range Snipers etc etc steve
|
#5
|
||||
|
||||
good point !! which ones ? as a collar dog could have been used any thoughts ? steve
|
#6
|
||||
|
||||
Blade width
Not sure if this helps but the width of my Officers Lancashire Fusilier blades are approximately 38mm apart though the upper central blade is a bit higher. To the bottom of the blade from the point of the lower blade it is 23mm though it may have been a bit longer.
Note the damage and 1 blade missing. Cheers Paul. Last edited by Paul Spellman; 23-05-14 at 10:09 PM. |
#7
|
||||
|
||||
Quote:
|
#8
|
||||
|
||||
Steve
Haven't got the measurements to hand but another one to look into Paddy |
#9
|
|||
|
|||
Given the possibilities of badges with blades, loops and also theatre made examples, the words 'Cinderella's' and 'slipper' spring to mind.
Good luck Steve. |
#10
|
||||
|
||||
I only want a badge that will fit with out adding a hole for a display next year !! Time I have . See you Sunday Steve
|
#11
|
|||
|
|||
Does it have a chinstrap with buttons? If so the buttons should tell the regt.
|
#12
|
||||
|
||||
The Welsh has 3 blades, but are not far enough apart to fit.
__________________
Regards, Jerry |
#13
|
||||
|
||||
HI Guys
some pics of the cap i was going to take it with me to farnham to have a look around for a badge that would fit but left it behind !!! eek ! steve |
|
|