|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cleaning/Polishing Badges
I recently came across a rare badge I need for my collection and this example is in sterling silver. Unfortunately a previous owner decided to clean and polish away decades of lovely patina. How much affect does cleaning and polishing a badge have on it’s value? I realize everyone has different opinions on this, but I would like to hear what others think about this.
|
#2
|
||||
|
||||
Cleaning silveris fine, I dont like dirty badges and I use a silver dip that doesnt harm them.
Polishing silver is a different matter as it obliterates the details and therefore can lower the value compared to an unpolished one. regards
__________________
Simon Butterworth Manchester Regiment Collector Rank, Prize & Trade Badges British & Commonwealth Artillery Badges |
#3
|
|||
|
|||
You should never "polish" sterling silver items. To clean is one thing, to polish is something else. Use "silver dip". This is a liquid which removes tarnish from silver. Immerse the item in the solution, leave it for several minutes. Remove it and rinse in cold water. Dry gently using a soft cloth. There should be no need to aggressively rub or polish the surface. Whether to clean or not is a personal decision.
Dave. |
#4
|
|||
|
|||
Always clean mine -lovely patina =,dirt /oxidisation How often do you see dirty badges in museum collections Some say don't clean badges as it to prove its genuine If you know what you are buying makes no difference Collecting approx 50 years.
just received today nice sterling silver medal first thing Idid was to clean it to get rid of the patina/dirt Last edited by 49lassiepen; 08-09-23 at 04:12 PM. |
#5
|
|||
|
|||
Removed duplicate
|
#6
|
||||
|
||||
I prefer to only clean dirt, verdigris or left over polish residue. Other wise I leave them as is. I basically use warm water a soft liquid soap and usually just my fingers, or if need be a very soft brush like is used for make up by the ladies. This is for no silver badges as I only clean dirt from those.
As has been said we each have our preferences, but I do like hearing what others think and do. Terry |
#7
|
||||
|
||||
Quote:
|
#8
|
||||
|
||||
An initial clean with Fairy liquid and toothbrush, assess if it needs Silverpolish, if it does the toothbrush comes in handy again, from a Grimy badge I have uncovered a Gem!
|
#9
|
||||
|
||||
I always clean my badges.
__________________
Cofion gorau Gruffydd M-J www.paoyeomanry.org.uk "A Yeoman from the Stalwart Rural Cavalry" Lechyd da pob Cymro |
#10
|
||||
|
||||
I also clean my badges that I post with medals to the same regiment..... There is no Seargent Major in the world will allow you to be on parade with dirty badges.....
Now how do I clean...... I use a polish that has a miniscule fiberglass abrasive rather than the grit that you find in polishes like brasso and silvo..... This does not scratch the metal on the badge and works fantastically on medals leaving no marks..... The other way I learned by accident..... Many years ago I purchased a badge that was very very dirty and had a lot of green verdigris on it and I accidentally left it in my pants pocket and it went through the wash..... When it came out it was as shinny as brand new.... If I have a very bad badge I put it in an old sock, tie a knot in the end and put it in the wash much to the dismay of the wife..... Mike
__________________
Calgary Military Historical Society OMRS 1591 Boer War Badges Want's anything named Clare or Cherer |
#11
|
||||
|
||||
As a minimum I will hand wash a badge with a neutral soap and water, using a soft tooth brush if necessary. This will remove dirt and oils (that even come from your hands / handling) that could lead to damage to the badge if left unchecked long enough.
For verdigris I find nail polish remover very effective in clearing it, using soaked cotton buds to rub it off. But give the badge a good wash afterwards again so all that chemical is removed. But AVOID using nail polish remover on or near anything plastic, as there is a very good chance it can melt the plastic. Whilst doing the above will remove the dirt and inevitably make the badge a bit brighter, it doesn’t affect the patina. Of course if there is staining to the metal / patina you don’t like, then it is out with the polish of choice. Again a tooth brush can be useful to get the polish in the nooks and crannies of a badge. Yes, you then have a shiny badge, but it will dull down again with time if preferred. The trick for a total clean after polishing is to then get rid of any polish residues with soap, water and tooth brush again. BUT you must use only cold water, otherwise hot water will obviously heat the metal and in the case of brass / gilding metal cause it to immediately loose it’s shine / go dull orange. Of course if you prefer your brass/GM badge dull, this will help it back on its way to that state after polishing. Cheers……John |
#12
|
||||
|
||||
Griff, after that wonderful success you had of restoring that burnt DHIY badge to glory, would you mind imparting some detailed insight into how you achieved your results please?
I am particularly interested in the use of vinegar and in what measurements / quantities should be utilised, as it is a method I have never tested. Cheers……John |
#13
|
||||
|
||||
Quote:
I use "neat" vinegar normally to get rid of decades of grease and crud on the surface of a badge, especially good for officers gilt badges... they come back to their original sparkle after a 30 minute dip in vinegar. * I wish I knew the back story to this one... sadly the seller didn't know it.
__________________
Cofion gorau Gruffydd M-J www.paoyeomanry.org.uk "A Yeoman from the Stalwart Rural Cavalry" Lechyd da pob Cymro Last edited by GriffMJ; 09-09-23 at 11:19 AM. |
#14
|
||||
|
||||
Thanks Griff And yes that DHIY is now a fine example of what some care and attention can achieve.
Cheers……John |
#15
|
|||
|
|||
Thank you gentlemen. Your posts have been educational and insightful.
Verdigris is one thing, patina is another. While I have cleaned badges, I have never polished one. Patina is any signs of ageing of an antique, whether it be fading, darkening, or oxidising, patination occurs on almost any material. Are there any instances where you would want to preserve the patina? |
|
|